Maxx Ice MIM50-O Manual de uso y cuidado descargar pdf (Pagina 6)

INSTALLATION

Remove packaging materials

IMPORTANT: Do not remove any permanent instruction labels or the data label on

your ice maker.

Remove tape and glue from your ice maker before using.

• To remove any remaining tape or glue, rub the area briskly with your thumb. Tape

or glue residue can also be easily removed by rubbing a small amount of liquid dish

soap over the adhesive with your fingers. Wipe with warm water and dry.

• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive

cleaners to remove tape or glue. These products can damage the surface of your

ice maker.

Cleaning before use

After you remove all of the packaging materials, clean the inside of your ice maker

before using it. See "Interior cleaning" in the Cleaning and Maintenance section.

Location Requirements

• This ice maker should be installed by qualified personnel.

• To ensure proper ventilation for your ice maker, the front of the unit must be com-

pletely unobstructed.

• When installing the ice maker under a counter, follow the recommended spacing

dimensions shown on the previous page. Allow 2/5" (10mm) or more clearance at

rear, 1/5" (5.1mm) at the sides and 1" (25.4mm) at the top for proper air circulation.

The installation should allow the ice maker to be pulled forward for servicing if neces-

sary.

• Choose a well-ventilated area with temperatures above 45°F (7°C) and below

110° F (43°C).

• The unit should not be located next to ovens, grills or other sources of high heat.

• Installation of the ice maker requires a cold water supply inlet of 1/4” (6.35mm)

INSTALLATION CLEARANCES

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Sin comentarios

Maxx Ice MIM50-O Manual de uso y cuidado Pagina 6