Maxx Ice MIM50 Manual de uso y cuidado descargar pdf (Pagina 21)

2. Make sure all ice is off evaporator. If ice is being made, initiate harvest or wait for cycle

completion, then turn machine off at the power switch.

3. Remove all ice cubes from the storage bin.

4. Keep the ice maker connected to the water supply. Pour 4 oz. of Nickel-Safe Ice Maker

Cleaner Solution into the water tank.

5. Turn on the power switch. Within 3 minutes press the Clean button. The machine will

go into the cleaning mode automatically.

6. Allow 30 minutes for proper cleaning. After cleaning, press the machine “ON/OFF”.

Drain off the waste water to another container by drain pipe in the front of the water

trough. You will note that the water will continue to fill the sump. Squeeze the hose

and put back into place so that the sump remains full of clean water. Note: Don’t drain

off the waste water to the inside of the cabinet.

7. Inspect the evaporator and water spillway to ensure all mineral residue has been removed.

If necessary, wipe the evaporator, spillway and other water transport surfaces with a clean

soft cloth to remove any remaining residue. Reassemble all components and repeat steps 4

through 7 as required to remove residue

8. Repeat step 5-6 above three times to rinse the ice-making system thoroughly. This will

complete ice-making system cleaning. Turn the incoming water supply off and drain out

the sump as indicated in step 6.

9. Prepare 1½ to 2 gallons (5.7 to 7.5 liters) of approved (EPA/FDA) sodium hypochlorite

food equipment sanitizer to form a solution with 100 to 200 max. ppm free chlorine yield.

10. Add enough sanitizing solution to fill the water trough to overflowing and begin the

cleaning cycle as indicated in 5, and allow circulation to occur for 5 minutes and inspect all

disassembled fittings for leaks. During this time, wipe down all other ice machine splash areas,

plus the interior surfaces of the bin, deflector and door with the remaining sanitizing solution.

Inspect to insure that all functional parts, fasteners, thermostat bulbs (if used), etc. are in the

correct position.

11. After sanitizing, press the machine “ON/OFF”. Drain off the waste water to another

container by drain pipe in the front of the water trough. Turn on the water and you will

note that the water will fill the sump. Squeeze the hose and put back into place so that

the sump remains full of clean water. Note: Don’t drain off the waste water to the inside

of the cabinet. Do not mix the sanitizer and the cleaner together, fumes could arise.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Sin comentarios

Maxx Ice MIM50 Manual de uso y cuidado Pagina 21